You are here: Home > Low Headroom

Super Low Headroom Garage Door Bracket


Low Headroom is a huge problem with homes trying to install modern day garage doors and openers.  Are you tired of hearing the same old thing over and over?  No clearance!  You can't install that there!  Sorry no room for an opener!  Well your troubles are over.  Does your situation look this bad?

When I first seen this Easy Swing Low Headroom Bracket system I was quite skeptical about the ability to install an overhead door with front-mount torsion springs in 6” of headroom with an opener.

We do a lot of low headroom installations and are quite experienced with the various low headroom kits available.

We just finished our installation of a 1-3/4” thick insulated steel door and opener in only  6” of headroom. The door runs smoothly and quietly and we feel we could have even gone another 1" or so lower.  AMAZING!

This is the best solution we ever worked with. 

Thank you


GUARANTEED TO WORK OR YOUR MONEY BACK!
Low Headroom Brackets
Sort By:
Page of 1
Low Headroom Quick Close Fixture w/ Rollers (Pair)
Our Price: $33.95
Low Headroom Quick Close Fixture (Pair)
Our Price: $29.95
Low Headroom Top Fixture (each)
Our Price: $1.95
Low Headroom Bracket Low Headroom Bracket
Super Sneaky Low Headroom Solution (Pair)
Our Price: $44.95
Super Sneaky Operator Extension Bracket
Our Price: $34.95
   
 

Quick Close Low Headroom Instructions

Adjusting the Top Clearance of Garage Doors for Low Ceilings

Our garage door rubs against the beams in our garage ceiling when we open it.  We would like to install a garage door opener, but the track would make it almost impossible!  My husband says we have to cut sections into our floor joists or cut into the door itself.  This is a terrifying prospect!  Is there another way?

You are not alone.  Many older homes have very low ceiling clearance in the garages. Rather than cutting into your structural members, notching the top of the door (which can dangerously weaken it) or destroying your concrete floor, there is an easier and less destructive solution.

There is a garage door accessory called a EASY SWING BRACKET It can be used on any sectional garage door that has clearance problems due to low ceilings or obstructions, allowing the garage door opener track to be mounted much closer to the top of the garage door OR on the actual spring mount for extreme conditions.

The top guides (which hold the uppermost garage door rollers) are replaced with these specially designed brackets that cause the top of the top panel of the door to move inward rather than upward as the door rises.  The result is that the top panel does not rise very much as the door opens, allowing the install in as little as 5".